Hi All
A few days ago I read the information available about the ArduPilot Mega board and also reviewed the schematics. I searched for the information on this site as well as the SourceForge repository. Since I design embedded systems for a living, I though
Read more…am i able to use the XTend 900 1W RPSMA - 40 Mile Range with a high gain antenna in place of the XBee Pro 900 Wire Antenna with the XBee Adapter kit - v1.1 for wireless telemetry with the ardupilot mega to utilize the Frequency Hopping Spread Spectru
Read more…It has been awhile since there has been a significant update for the JSBSim Sfunction project, but finally we are pretty close to a new release that has some cool new features. The most significant of these is the addition of the FlightViz 3d visual
Read more…Hi All,
I would like to know is there any way that can test whether a brushed ESC is working or not ?
Read more…Is there a recommended GPS unit for UGV's? Does the IMU work well enough with regular GPS modules to keep a vehicle on the road?
I'm just wondering if i were to program a rc car to go around a large track, what would i need so that it would not go off
Well here it is, the first DCM propeller code (that I have seen). This is based on the wealth of work put forth by Bill Premerlani and others on the Ardupilot/matrix pilot side. I must admit that this is the first enormous coding project that I hav
Read more…I am having problems with my recently purchased mediatek GPS, i'm quite new to this so there is probably something obvious im doing wrong....
I have the mediatek GPS module and the adaptor bought as bought from the DIY drones store and the basic arup
Read more…I am New to this and already I am addicted! I am with a group of people who are trying to build a UVA for a school project. I am wondering if you guys (and Girls) could just go over our shopping list and see if we have everything. also if you think a
Read more…I made an early purchase of the MediaTek GPS before the adapter boards were available so it came with the original firmware. I purchased an adapter board, attached the GPS, and was able to successfully upgrade the GPS firmware using the MediaTek prog
Read more…hi new to the uav world just took an interest in the last week i have been flying rc aircraft for a while now but i am keen on the outback challenge.
my question is , is the ardupilot mega able to be programed to suit the rules of the competition the
Read more…Yello people,
Hey guys,
Hi all!
I'm using a MaxSonar EZ1 for range sensing triggering via the RX output pin (and usnig PW for data). I hooked it up and it does provide me with readings. However, I noticed a high degree of fluctuation in the data. The readings would be 51 for
Hi guys, I just managed o burn the matrixPilot v25 into my new UAV v2. I did some testing of the IMU and it seems to work. I have all the docu to read about configuration and groundtesting. I`m planning o try it in a styrofoam glider with a 400 elect
Read more…Hi all...
new to this, so sorry if I'm reposting or have this in the wrong place, but can't find any info on this
As I say I'm new to all this... I want to set up a test environment in my workshop
However I don't want to use batteries in this setup, i
Read more…Hi,
If I programme a mission on Ardupilot, but go back to manual part way throug that mission, what happens if I then go back to AUTO?
Will it conitue where it left off or start over again??
Also, can you fly the same mission multiple times without r
Read more…Hi there,
Where in the code can the altitude for Return To Launch- RTL be fixed?
What altitude does Ardupilot consider for Return To Launch- RTL?
What does the parameter #define AIRSPEED_RATIO 0.1254 do?
When should I increase it and when should I decrea
