Gender
Male
About
About Me:
.
Please tell us a bit about your UAV interest
Building in progress of a Quad \ octo copter
Activity Feed
"Darren,
There was a short period to wait until we ship,
now they are in stock and no problems. - If you place your order now we are shipping immediately."
There was a short period to wait until we ship,
now they are in stock and no problems. - If you place your order now we are shipping immediately."
"Ted, will make it usually in 10-20 days.
Hein - you receive the soldering schematics physically with your kit !"
Hein - you receive the soldering schematics physically with your kit !"
Compatible at 100% of the purchases ! We finally have some 6-Position mode switch DIY kit, compatibility info for new users ! Tested compatible Transmitters:Turnigy 9x 7 UsersTurnigy 9x ER9x Firmware 4 UsersFutaba T10CG (removing the CamPac…
Hi,I am looking for the right choice for 8 motors for an heavylift Octo.The frame is carboncore Octo 100cm, with megaradius gimbal.Total weight predicted - about 7kg, maybe up to 9kg with payload and extra batteries.I need some advice choosing the…
"Simone, The schematic is even shown above in this post ! you will get a printed version of it and the components needed.
Taylor, Congrats ! please come back and tell us how it works for you"
Taylor, Congrats ! please come back and tell us how it works for you"
"Of course, the switch must replace an existing continuous potentiometer on your TX.
you can't replace a 2 or 3 position switch with this one and expect it to work, though it might, depends on the TX."
you can't replace a 2 or 3 position switch with this one and expect it to work, though it might, depends on the TX."
Well, technology is developing fast, but one issue always remains: how to config the TX to allow 6 modes...Here is a 6 modes switch for ANY Transmitter !Enter for detailsThe idea is to have 4 trimmers to allow precise setting of the wanted PWM value…
"Good news.
just a small question - will you have a MORE powerful motor than the 2836 ?"
just a small question - will you have a MORE powerful motor than the 2836 ?"
"how is it possible to connect an external GPS on APM2 with an onboard GPS ?
Thanks"
Thanks"
"does it use the sonar to auto land ?
it would be really cool to use the sonar:
drop fast while above 4 meters, then slow down the descend,
and do the last meter or 50cm really slow and gentle"
it would be really cool to use the sonar:
drop fast while above 4 meters, then slow down the descend,
and do the last meter or 50cm really slow and gentle"
"Bernard, true, but one should assume every basic circuitry has a low value capacitor in it to filter noise.
this is more for heavy consuming "power hungry" devices"
this is more for heavy consuming "power hungry" devices"
"yes it is zoomed, but these spikes are still very big relatively,
it's that short actual moment when the motor's coil is being connected and draws a lot of power, just before the 5v regulator detects the lower voltage and start to compensate."
it's that short actual moment when the motor's coil is being connected and draws a lot of power, just before the 5v regulator detects the lower voltage and start to compensate."
This voltage protector offers 3,300,000 uF of energy storage in a small and lightweight package..more powerful multicopters bring us the opportunity to use bigger cameras, very big and complex gimbals, and of course big and powerful servos.a servo,…
"this looks OK since every one of the ESC has the same length of wires. (red and black added)"
"got it right with arduino 0.22
strange..."
strange..."
